1.00.00 Initial Release 1.00.03 Updated RTCC drive level 1.00.10 Added Legacy mode option for backward alarm/alert compatibility with 1.5.23 and older software Buoy test/cal fix non stop service mode entry Remote cal/test request fix Xtend programmer Fail fix 1.00.11 One shot timer 1 pond set enable fix 1.00.12 Harvest buoy repeat fix 1.00.20 RM420 Master fix 1.01.02 Remote firmware capability 1.02.00 Add Solar Mixer, Smart timers, Remote firmware upgrades, new Status 1.02.04 Mains monitor min fix, Exception debugging, down key lock 1.02.05 Packet safety, negative DO calcs safety 1.02.06 Mains off timeout 1.02.07 Upped stack sizes added CPU USB dump repaired non saving configs Changed solar mixer to one shot 1.02.08 Internal optimization on CPU usage (ARQ) 1.02.09 Fix negative probe issue, add negative min mv range 1.02.10 Fix restarts after probe error, Upper probe range extend 1.02.20 Re-work and add to probe unstable detections. Rise in post, cycling in test, fall in cal. Added soft detect of service for 4 day cal spurious alerts Added reverse Xtend RSSI reporting Native Gen 2 config Reporting Full syslog read, one line per request Changed Min bromine check to 4.0 Scaled Unstable ranges to 40.0mV center Changed Min Max temp table Added RSSI to face upper left corner Fix Xtend read issue 1.02.21 Added remote Amp offset adjust by turning on Sensor breaker 1.02.22 Fix low threshold false Probe unstable @ Run 1.02.23 Added Master/Slave light sensor, with rs485 seeed sensor support 1.02.24 Fix Probe Unstable @ Run on Flat Lines 1.02.25 Probe Unstable changes, change hours from 6 to 10 or 11, twice on @ run 1.02.26 Period pre change on DO calculation 1.02.27 Remote aeration repairs, was not sending amps, and fast sync stayed active. 1.02.30 Fix Buoy timeout not setting Dampened DO to 0.0 1.02.40 MotherBoard Rev 10 support 1.02.50 Extender support, Aeration step off on IO entry, add queue to modbus driver 1.02.60 Fix missing generator alerts